Morphy Richards 47507, Manual

Page: 6 / 20

6
www.morphyrichards.com
Steam function
The froth attachment makes it easy
to produce frothy milk for
cappuccino.
Ensure the coffee/steam lever is in
the off position.
1 Before using the steam nozzle,
remove the filter holder.
2 Attach the froth attachment È to
the end of the steam nozzle Í P .
• For the froth enhancing attachment
to work properly it must be pushed
firmly onto the steam nozzle.
3 Fill the water reservoir with cold tap
water.
4 Swing the steam nozzle with the
froth attachment to the side of the
coffee maker.
5 Press the hot water/steam selector
switch
‹ , the steam symbol will
flash. When the coffee maker is
ready to make steam it stays on.
6 Pour cold milk into a suitable jug.
Use approximately 100ml for each
cappuccino.
• For best results we recommend to
use refrigerated milk and a stainless
steel jug that is well chilled.
7 Hold the jug under the steam nozzle
so that the head of the froth
attachment is immersed in milk and
push the lever up to the steam
setting
Q . The coffee maker makes
a pumping noise, this is normal.
• Do not allow the tip of the nozzle to
touch the bottom of the jug
because this could obstruct the
passage of steam.
8 Once the froth has been produced
push the lever down to the off
position and remove the jug.
• Do not be alarmed by the escaping
steam from the base.
The milk is ready as soon as it forms
a soft, thick layer of foam on the top.
If the milk starts to make large
popping bubbles, the milk has boiled
and it will not froth. If this happens
replace with chilled milk. Do not boil
the milk.
Frothing tips
• For best results use fresh, cold milk
from the refrigerator.
• Skimmed milk or fat reduced milk
will make frothing easier.
Hot water drinks
You may want to top up your
espresso with hot water for a longer
drink or to make other hot water
drinks such as tea or instant soups
using the steam nozzle.
If the machine has been
in use:
1 Take care when removing the froth
attachment
Ë from the steam
nozzle, È it may be extremely hot.
2 Ensure the water reservoir Î is
filled with cold tap water.
3 Swing the steam nozzle È to the
side of the coffee maker.
• Take extreme care when handling
the steam nozzle it may be
extremely hot.
If the machine has not
been in use:
4 Ensure the unit is cold before
removing the froth attachment
Ë from the steam nozzle.
5 Ensure the water reservoir Î is
filled with cold tap water.
6 Swing the steam nozzle È to the
side of the coffee maker.
7 Switch the unit on by pressing
the on/off switch
› . The blue
‘power light’ ¤ and display Í will
illuminate.
Tips
Choose a finely ground espresso
coffee to use with this coffee maker.
Avoid blends that are very powdery.
When the coffee is too finely ground
it may block the filter.
For best results cups should be
warmed. Cups should be placed
upside down on the warming plate.
Please note that this may take up to
20 minutes depending upon the type
of cup used.
47507MCZ-Rev1-PumpEspresso 25/9/06 4:20 pm Page 6