12
UK Helpline 0844 871 0960
Replacement Parts 0844 873 0726
Ireland Helpline 1800 409 119
3. DRY IRONING
Always make sure there is water in the tank
otherwise the LOW WATER indicator will
activate.
1
Always make sure the water tank is quarter
full, otherwise the LOW WATER INDICATOR
ICON will activate.
2
Connect the unit to the mains supply.
3
The LCD display screen will illuminate for 1
second accompanied by a short beep sound,
the unit will then turn off and will remain in
STANDBY mode until re-activated. The
STANDBY ICON will be visible in the corner
of the display screen.
4
Press the POWER STANDBY button to
activate the unit and set the iron temperature
dial to the dot setting required.
5
Press the STEAM +/– buttons until the
NO STEAM ICON is displayed on the LCD
display screen
L
.
NO STEAM
6
Turn the temperature dial on the iron to the
dot setting required.
7
The temperature indicator light on the iron
will glow indicating the iron is heating.
8
When the required temperature is reached,
the temperature indicator light will go out and
the iron is now ready to use. It is always a
good idea to begin with “cool fabrics” and
work up to higher settings. An iron heats up
quicker than it cools down so you’ll save
time and electricity.
9
The AUTO STANDBY feature will activate if
the iron is not used for 15 minutes. Press the
POWER STANDBY button or the iron steam
trigger
⁄
to reactivate the unit.
WATER SPRAY
(certain models only)
Certain models are fitted with a water spray
feature. Stubborn creases and excessively
dry clothing can be softened by damping the
material with water. This procedure means
ironing can be achieved without applying
excessive pressure.
Filling water spray tank
M
To fill the water spray tank with water, press
the release button
Ì
and lift away the spray
unit
Î
.
Pull the tank
Ó
away from the spray unit in a
downward direction, taking care not to
damage the tank, and fill water to the ‘Full’
mark.
Water spray unit
(certain models only)
Î
Spray unit assembly
Ï
Spray button
Ì
Spray unit release button
Ó
20ml spray bottle
Re-assembly
M
Attach the tank to the spray unit, taking care
to align the parts correctly.
Locate the spray unit to the front of the iron
and press it home until the unit locks into
place.
Press the pump
Ï
a few times to purge the
air from the system, when a fine mist of
water is created, the unit is ready for use.
L
Î
Ó
Ì
Ï
Î
M
RN42236MUK Rev2_Instruction Book 25/10/2010 11:38 Page 12
