Adjustments 1 and 2
With the fold plate removed from the machine, slide out the lower cover. Release
the locking screw (X) with a 3mm allen key.
Adjustment 1 continued
The adjusting screws (Y), one each side, located through a spring, may now be
turned using a 4mm allen key until the lower rail is at the desired position. Generally
for heavier stock this is further away from the rollers.
Adjustment 2 continued
The adjusting pad screw (Z) can be found in the upper rail by turning the fold plate
over (the upper cover need not be removed). Using a 2.5mm allen key, adjust the
pad until the desired adjustment is obtained.
You must tighten the locking screws (X) each time to give an accurate
measurement.
CAUTION
DO NOT OPERATE THE MACHINE WITH THE LOCKING SCREWS (X) LOOSE.
MAXIMUM GAP BETWEEN THE RAILS (ADJUSTMENT 2) IS 2.5 MM AT THE
CENTRE POINT. (CHECK WITH 2.5 MM ALLEN KEY). SERIOUS DAMAGE CAN
OCCUR IF THE MACHINE IS OPERATED WITH THE FOLD PLATES SET AT A
GAP IN EXESS OF 2.5 MM.
19
