Page 22
CREASING
SECTION 9
Installation Procedure.
To update Machine Software.
1. Note the current machine calibration settings.
2. Power down the machine and remove the power cord.
3. Replace the USB Flash Drive.
4. Power the machine up.
5. To access the machine menu, open the calculator and type 608888; then press X to exit
the calculator screen.
6. Choose the machine type from the list and then perform a power cycle when prompted.
7. Re-enter the calibration settings.
(I) Check the Boot Code version is V2.0 or later by pressing the Tools Tab and then
selecting the 'i' button. (if V2.0 or later is not shown, then updating is not possible).
(ii) Press the Machine graphic 1 , followed by the leftmost tab 2 .
(iii) Press the Display graphic 3 , followed by the 2nd tab from the left 4 .
(See NOTE:- below).
The 2nd tab from the left is the Crease Setting tab on the Autocreaser Pro and
Documaster Pro machines.
The 2nd tab from the left is the Fold Setting tab on the Docufold Pro machine.
The 2nd tab from the left is the Roller Gap Settings tab on the Digifold Pro and
Autofold Pro machines.
Boot Code Version
(iv) Choose the latest version of the machine software from the list to update the machine
program chip.
NOTE:-
