Morgan PLUS SIX, Owner'S Handbook Manual

Page: 46 / 73

43
BATTERY
The Morgan Plus Six uses a “maintenance free” battery which is located under
the bonnet on the passenger side of the vehicle. If the battery is required to
be removed from the vehicle this should normally be performed by a Morgan
dealer. Whenever the battery requires removal/refitting, the terminals should be
cleaned and covered in petroleum jelly.
The battery will discharge gradually if the vehicle is not used. If the vehicle is left
standing for more than 2 weeks then it is advised that a battery conditioner is
used to maintain the battery correctly. If a battery is allowed to discharge fully
this will damage the battery leading to failure and this will not be covered on the
vehicle’s warranty.
WARNING Batteries contain acid based liquids; avoid contact with skin,
eyes or clothing. If battery acid is in contact with the skin or eyes flush with
copious amounts of water. Remove contaminated clothes immediately. Seek
medical attention. If ingested do not induce vomiting or ingest any fluids,
seek immediate medical attention.
WARNING Batteries produce explosive gases; keep isolated from
potential ignition sources.
WARNING Ensure battery terminals are always isolated.
WARNING Observe all warnings as shown on the battery.
WARNING Always disconnect the battery when working on a vehicle.
WARNING Never short circuit a battery, short-circuiting a battery may
result in serious burns.
BATTERY REMOVAL
If the battery is required to be removed from the vehicle this should normally be
performed by a Morgan dealer.
To remove the battery, locate the negative terminal on the top of the battery
(1). It has a minus (-) symbol stamped into the rubber cover. Pull back the cover
to reveal the terminal post and clamp. Loosen the clamp, pull it off the battery
post and carefully secure the lead to prevent it springing back and reconnecting
with the post.
Locate the positive terminal on top of the battery (2). It has a plus symbol (+)
stamped into the rubber cover. Pull back the cover to reveal the terminal post
and clamp. Loosen the clamp, pull it off the battery post and carefully secure the
lead to prevent it springing back and reconnecting with the post.
1 3 2