Morgan PLUS SIX, Owner'S Handbook Manual

Page: 17 / 73

14
INSTRUMENTS
Speedometer (1 RHD, 3 LHD)
The speedometer indicates the road speed of the vehicle. The display is miles per
hour (mph) and/or kilometres per hour (kph).
Clock (2)
To advance the hands in a clockwise direction, carefully press the small right-hand
button on the clock face (using a small, blunt device makes this easier). Pressing
the button once will advance in one minute increments. If the button is held down
for longer, a continuous movement of the hands is achieved. The left-hand button
acts in the same way, except the movement is in an anti-clockwise direction.
Tachometer (3 RHD, 1 LHD)
The tachometer displays the engine speed in revolutions per minute (rpm).
WARNING
Excessive rpm used when an engine is not at normal running
temperature may cause premature wear, damage to the engine and failure
of engine components.
Odometer (4 RHD, 13 LHD)
Located in the LCD screen in the bottom of the speedometer, the odometer
records total distance that the vehicle has travelled.
Trip Meter (4 RHD, 13 LHD)
Located in the LCD screen at the bottom of the speedometer is the trip meter,
which can be used to record a distance from a set starting point.
Trip Reset Button (5 RHD, 12 LHD)
The trip meter can be re-set to zero by pressing and holding the button.
PUSH BUTTON SWITCHES
Heater Fan Control
(6 RHD, 5 LHD)
Rotate the Heater Fan Control knob clockwise to increase fan speed. Rotate
anti-clockwise to reduce fan speed. A Heater Fan Control icon appears in the
Driver Information Panel.
Footwell Vent
(7 RHD, 6 LHD)
When pushed on, the switch will display in white. Air is directed into the footwell.
Air Conditioning
(8 RHD, 7 LHD)
When pressed, cold air will be directed through the heater vents. The engine
speed may slow for a short time when first switched on. Press the button again
to turn off.
CAUTION Make sure the heater vents are open before turning on
the air conditioning.
Ignition/Engine Start
(9 RHD, 8 LHD)
With the ignition key set to the second position, press and hold the brake pedal
then push the Start button to start the ignition. Press and hold the button to
start the engine. There may be a short delay after pressing and holding the Start
button before the engine engages.
NOTE: The engine will not start unless the foot brake is depressed firmly.
Hazard Warning Switch
(10 RHD, 9 LHD)
When pushed on the switch will flash red in conjunction with all the direction
indicators on the vehicle. The left and right indicator icons in the Driver Information
Panel will flash. Hazard lights should be used in an emergency. In the case of an
emergency, move the vehicle to a safe position and turn the hazard lights on.