4
IMPORTANT SAFEGUARDS
5
MOVING AND INSTALLING
• Do not touch food or metal objects stored in the freezer compartment with wet hands.
• Do not put frozen food straight from the freezer compartment into your mouth. Risk of
low-temperature burns!
•
WARNING:
–
Do not damage the refrigerant circuit as leaking refrigerant may ignite or cause eye
injuries. Wash the eyes at once and see a doctor.
– Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer (i.e. heaters, electric ice makers,
etc.).
– Do not operate microwave oven, rice cooker and voltage regulator on the top of the
appliance.
– Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear
of obstruction.
– To avoid potential hazards related to appliance instability, ensure proper assembly
according to the instructions.
– Connect to potable water supply only.
MOVING
• Lift and move the appliance by touching the bottom.
• Do not carry by touching the door or door handle.
• Do not carry the appliance transversely or reversely.
• The appliance has 2 wheels on the back.
• Lift the front side up and move the appliance using the 2 wheels
on the back when moving.
• The incline angle should be less than 45°.
PARTS IDENTIFICATION
1
2
3
1.Thermostat
2.Drawer
3.Door
>45º
INSTALLING
• Install the appliance in a dry and ventilated room.
• Recommended placement distances:
– from the side panels to wall: 10cm minimum.
– from the back to wall: 10cm minimum.
– from the top to wall or ceiling: 30cm minimum.
m
in
.
1
0
cm
mi
n.
10
cm
VENTILATION
• The air at the back of the appliance will heat up. This warm air
must be allowed to freely escape to avoid overburdening the
appliance’s performance and increasing power consumption.
• Do not cover or block off the ventilation holes for the compressor.
• Do not put heating sources near the ventilation holes.
• Do not expose ventilation holes to direct sunlight.
ADJUSTING THE FEET
• There are 2 feet on the front bottom.
• Place the appliance on sturdy & horizontal ground.
• Adjust the feet screws by wrench (See the picture) to ensure the
feet screws are touching
• vertical and stable position.