Morgan MBH-SD2112 User Manual Download Page 6

10

11

OPERATING INSTRUCTIONS

TROUBLESHOOTING

ADDITIONAL SAFETY INFORMATION

•  Check whether the gaps in the ring caps are clogged.
•  Clean with a sharp object or wire brush, or similar object.
•  Dry burner caps after washing.

2. AIR REGULATOR ADJUSTMENT

  Correct adjustment of the air-regulator can achieve the best combustion effect. The valve

    body damper handle is located at the bottom of the hob.

  This hob has been installed with a 

    double-layer fixed air-regulating plate 

    slot, which allows better adjustment of

    the air inlet and prevent unnecessary 

    missteps.

  Due to factors such as regional gas 

    composition and pressure instability, it

    is necessary to adjust the valve body 

    damper handle during the first use to 

    avoid undesirable phenomenon such 

    as yellow flame (red flame), flame off, 

    and backfire.

CLEANING & MAINTENANCE

  Before cleaning, ensure the hob has cooled down completely and that the gas supply is

    switched off.

  Clean the hob with a damp cloth with mild cleaner. Do not use chemicals, steel wool or 

    abrasive cleaners to clean the hob.

WARNING:  DO  NOT  IMMERSE  THE  HOB  INTO  WATER.  ENSURE  THAT  THE

APPLIANCE IS DISCONNECTED FROM THE GAS SUPPLY BEFORE CLEANING.

USING THE SMALLER PAN

  The smallest pan to use is the 120mm diameter pan. For your convenience, place a larger

    pan to support the one with a smaller smaller diameter (>=120mm, <=130mm) before use.

  Exercise caution when handling the pots as they are hot during operation.

CAUTION:

1.  Do not use cookware that overlaps the hotplate edges.
2.  

CAUTION:

Prolonged use of the appliance may 

    require additional ventilation. This includes leaving a 

    window open or increasing the level of mechanical 

    ventilation where available for more effective 

    ventilaton.

3.  

CAUTION:

Should the hotplate glass break, shut off all

    burners and electrical heating elements immediately. 

    Isolate the appliance from the power supply and do not

    use or touch the appliance.

Consistently cleaning the blocked burner crevice to prevent backfire. During cooking,

prevent gravy from overflooding the gravy tray.

The  burner  crevice  is  blocked  by  gravy  due  to  over

flooding. This will lead to:
1.  Backfire, which may cause glass to break.
2.  Flame will extinguish or unable to maintain its ignition.

•  

Note that the manufacturer or sales agent will not be held 

     responsible in the event of any glass breakage.

•  

Wash the burner cap with water to clean away gravy residues or

     soot. Do not wash the cap when it is hot after operation.

•  

Then use a fine needle, pin or wire to clean the obstructed  

     crevice.

•  

Fit back the cap when it is completely clean and dry.

 

 

 

 

 

 

 

 

 

Off Flame

Left Air

Regulator Handle

Right Air

Regulator Handle

Yellow Flame

Normal

 

 

   

 

 

120mm

Flame Burning Phenomenon

 

 

 

Burner Cap

Toothbrush

F

 

 

•  Ensure cap is mounted in place.
•  Gas distribution may not be stable if caps are not mounted

   correctly.

Burners, Burner Cap, Pan

Support

Control Panel

Burner Cover

Gas Hose

Gas Panel

 

 

 

 

 

 

•  If dirty, use a soft cloth dampened with mild detergent solution to wipe off the dirt.
•  Do not use Benzyl or thinner for cleaning as these may damage the plastic parts.

•  Ensure gas hose is tightly secured over the gas supply outlet and tighten with a clamp.
•  Replace the hose immediately if cracks are detected.

•  Use a soft cloth to wipe off dirt or stains on the cook top.
•  Be sure to wipe off dirt or stains immediately to prevent them from hardening and damaging

   the cook top coating material.
•  For stubborn stains and dirt, use a soft cloth dampened with neutral detergent solution.
•  The cook top coating material is vulnerable against physical force or high temperature. 

   Therefore, the following MUST be kept in mind:
   –   DO NOT use alcohol swabs, polishing powder, cleanser, sharp knife, alkaline detergent

       or bleaching solution to clean off any dirt or stains.

   –   DO NOT expose cooker to any physical force.
   –   DO NOT expose cooker to excessive heat by covering the burner with a large iron plate

       or large pot.

•  It is normal that after frequent use:
   –   The gravy tray or pan support will be scratched
   –   The Burner might be discoloured or turn the surface to white after exposure to constant

       high heat.

•  All the above situation will not affect the usage of the stove.

Over

 Floo

ding

Clearing of Soot

B

 

Fine Needle/Fine Wire

Summary of Contents for MBH-SD2112







Reviews: