iSND8
– Surround sound module
Hardware: V1
Firmware: V1
Version: V1.1
Manual: iSND8-1722-EN
Pág.
2
/
3
Image 1
MDiBus connections:
To connect MDiBus module must be used a CAT 6 UTP cable
with RJ45 connectors according to EIA568A or EIA568B
standards.
Outputs connections:
Do not connect speakers with impedances below 4 Ohms.
15VDC Power supply connection:
It is recommended to use iPSE156 power supply provided
with the iThink module. This should be connected to the DC
IN of the iSND8 module.
Sound inputs connections:
The iSND8 module has 11 audio inputs, where 3 (A, B and C)
of the plugs are audible in all 8 outputs and 8 dedicated, each
dedicated input corresponding to each output.
The sound input (IN A+B) must be connected to the iThink
module according to the Image 2.
Image 2
If the installation requires more than 8 independent SOUND
points, you can connect multiple iSND8 modules cascaded.
To connect two or more iSND8 modules to the same channels
A and B you can make connections according to Image 3.
Also applies to channel C.
LEDs
