20
© 2017 Maka Technologies Group. All Rights Reserved.
Getting
Started
Installation of your TX1 FHD Digital Roadcorder
TM
Charging
the
battery
Use the charger to charge the battery before using it for the first time. Charge
the device by connecting front camera via the USB car charger. Use only Maka-
approved chargers, batteries, and cables. Unapproved chargers or cables can
cause the battery to explode or damage the device.
Connect
the
Micro USB
car
charger
to a
charging port output that
support 12V to 24V.
•
When device detects no power supply, it will automatically switch off in 5
seconds time. To turn on the device again, you will need to press on the
on/ off button to manually switch it on.
•
If the battery is completely discharged, the device cannot be turned on
immediately when the charger is connected. Allow a depleted battery to
charge for a few minutes before turning on the device.
Connecting
the
charger
improperly
may
cause
serious
damage
to
the
device.
Any
damage
caused by
misuse
is
not
covered
by
the
warranty.
•
The device can be used while it is charging, but it may take longer to fully
charge the battery.
•
While charging, the device may heat up. This is normal and should not
affect the
device’s lifespan or performance.
•
If the device is not charging properly, take the device and the charger to a
Maka Service Centre.
