Morad Antenna Co. – 909 Squalicum Way, #106 – Bellingham, WA 98225 – (206) 789-2525
ANTENNA LIMITED WARRANTY CERTIFICATE
Note: Failure to follow assembly and/or installation instructions will void all warranties
Morad
Antenna Company
(Morad) warrants your antenna or related Morad accessory for two (2)
years from date of original purchase against manufacturing defects in material and workmanship
in accordance with the following terms and conditions. This warranty applies to the original purchaser
only and is not transferable.
l . During warranty period, Morad will repair without charge, valid defects in material and
workmanship. Warranty does not apply to units that have been damaged through accident, misuse,
negligence, modification, alteration, abuse or normal expected wear. Damage that is determined to be of
this nature will be repaired at customer's expense.
2. Repairs or adjustments covered under this warranty are to be determined by Morad.
3. For your protection, we require proof of original purchase date for warranty determination; sales
invoices or canceled checks are satisfactory evidence. This procedure ensures you that you receive full-
term warranty from the date of original purchase rather than date of shipment to dealer showroom.
4. All packaging and shipping charges to return units for repair are the responsibility of the customer.
Please pack units carefully, in their original containers if possible, to eliminate shipping damage. We
recommend insuring the shipments against loss or damage. Return units to: Morad Antenna Co., 909
Squalicum Way, #106 Bellingham, WA 98225. Please include a detailed description of the problem
you are experiencing along with your proof of purchase. Morad will return the repaired unit to you
prepaid if under warranty. Inquiries concerning the status of a warranty claim may be sent to the above
address or you may call (206) 789-2525 or email
5. This warranty gives you specific legal rights, and you may also have other rights which vary from state
to state.
ANTENNA MODELS WITH FIBERGLASS TIPS
When installing fiberglass tip on coil, be sure to tighten
locking nut as tight as possible. This will prevent tip from
vibrating loose and allowing water to get inside coil
causing damage to antenna.
ANTENNA MODELS WITH STAINLESS STEEL
TIPS Insert tip to theoretical mark (black ring) and
tighten lock nut only enough to keep tip from sliding.
Tip may then be adjusted in or out to obtain optimum S.
W.R. After adjustment has been made, using two 10"
wrenches, tighten lock nut one more FULL turn.
Improper tightening will allow tip to vibrate loose and
may cause permanent water damage to coil assembly.
USE NO LUBRICANT!
