This vehicle may be equipped with a “Factory Installed” hood switch harness. This har-
ness will not be visible but will be secured to the factory harness located just below the
TIPM. If this harness is present, Refer to step “a” in the “Hood Switch Harness Installa-
tion” section below and connect the hood pin switch as described, then proceed to “Re-
mote Start Antenna Installation” and continue with this instruction manual. If this vehicle
DOES NOT have a factory installed hood switch harness (one is supplied in the kit), pro-
ceed with the complete “Hood Switch Harness Installation” procedure.
Disconnect Ground From Battery
1. Remove ground from battery
a. Using a 10 mm socket, remove the negative battery cable.
Installation Procedure:
Validation Process
1. Press ----- ECU VIEW
2. Toggle down and highlight ----- TIPMCGW CENTRAL
GATEWAY
3. Press ----- MORE OPTIONS
4. Press ----- ECU DETAILS
5. Press ----- CONFIG INFO
6. Toggle down, verify:
Name
Value
REMOTE START PRESENT
SET
Factory Harness
Location
5 of 17
