13) Pull out and disengage floor console wings from
the center console.
14) Lift up the front of floor console and unplug 3-way
power outlet connector.
15) Carefully move floor console into the back seat
and out of the right rear door opening.
16) Place floor console upside down on a clean, pro-
tected surface.
K6859438
07/22/2005
Page 3 of 9
2) Measure/mark as shown and trim out connector opening using a sharp utility knife or air saw.
3) Measure/mark as shown and drill two 6mm connector mounting holes.
Power
Outlet
Floor Console
Floor Console
(Upside Down)
B – Modify Floor Console:
1) The two areas shown at left must be trimmed/
drilled to accommodate the VES front bracket
12-way connector. Follow the measurements
shown below.
