MAN199_0
www.moosesound.com
4
Connections and Controls
Please refer to the following scheme and instructions:
FRONT PANEL:
REAR PANEL:
1. POWER SWITCH:
Illuminated on/off switch. Before switching on the system, always adjust the volume to zero.
2. CHANNEL 1:
Gain control for Ch. 1. Turn clockwise to increase gain and counter clockwise to decrease gain.
3. CHANNEL 2:
Gain control for Ch. 2. Turn clockwise to increase gain and counter clockwise to decrease gain.
4. CH. 1 CLIP:
This LED will light dimly and increase in brilliance as clipping becomes more severe, staying on until
clipping ceases;
5. CH. 2 CLIP:
This LED will light dimly and increase in brilliance as clipping becomes more severe, staying on
until clipping ceases;
6. CH. 1 PROTECT:
When a problem occurs that causes a channel to go into a Protection Mode, this Led lights
and stays on until the problem is solved;
7. CH. 2 PROTECT:
When a problem occurs that causes a channel to go into a Protection Mode, this Led lights
and stays on until the problem is solved;
8. BRIDGE/STEREO:
Selector used to choose between STEREO and BRIDGE Operation Mode. In STEREO mode,
each channel within the pair remains independent, and each may be used for a different signal. In BRIDGE mode,
the setting combines both channels of a pair into a single channel with twice the output voltage. Use only the
input and gain control channel 1. Set the channel 2 gain control at minimum.
9. STEREO:
This LED lights up when the Amplifier is operating in Stereo mode;
10. BRIDGE:
This LED lights up when the Amplifier is operationg in Bridge mode;
Professional power amplifiers
CA1000 & CA2000
5
3
7
10
8
1
20
17
15
16
11
13
14
12
18 19
S
U E
F
INPUT CONFIG.
CHANNEL 1
(BRIDGE)
CHANNEL 2
CLIP
PROT
0dB
-
0dB
-
BRIDGE
STEREO
POWER ON
CA1000
PROFESSIONAL POWER AMPLIFIER
6
9
2
4
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
To prevent electrical shock
do not remove the cover.
No user serviceable parts inside.
Refer service to qualified
personnel only.
INPUT (BRIDGE)
INPUT
+2 -2
+1 -1
BALANCED
UNBALANCED
PIN
SIGNAL
2
1 / 2
3
1
2
3
1
GND
-
+
GND
+
3
1
2
INPUT
OUTPUT
CHANNEL 1
CH1
SPEAKER
+1 -1
CH2
SPEAKER
CHANNEL 2
BRIDGE
LIFT
GND
+1 -1
4 Ohm
PIN
SIGNAL
MIN. LOAD
CHANNEL
+2 -2
8 Ohm
BRIDGE
moosesound.com
FUSE F A
230V AC
50HZ
VA
PROUDLY DEVELOPED
AND MANUFACTURED
IN PORTUGAL