9
ASSEMBLY AND DISSASSEMBLY
The scooter has been designed to assembled and disassembled quickly
and easily without the use of tools. Should you need excessive force
when you assemble or disassemble your unit, you are probably doing
something wrong and should refer to the User’s Guide, then try again.
PIECES
The scooter consists of the following main modules, which you can put
together or dismantle without using any tools:
(1) Front chassis (2) Rear chassis (3) Seat (4) Battery-box
ASSEMBLY
(1) Position the front and rear sections of your scooter and shown in
figure A
(2) Align the lower curved locking brackets of the front section with
corresponding pegs on the front of the rear section. See figure B
(3) holding the seat post slowly pivot the rear section forward until the
curved locking bracket is fully connected onto the top rear pegs. See
figure C&D
(4) Loosen tiller adjustment knob, raise the tiller, and then retighten the
tiller adjustment knob.
(5) Secure the toggle latch.
(6) Place the battery box into the battery compartment and then place the
floor mat on it .
(7) Join all cables with the same labeling.
(8) Adjust the height of the seat by bolt on the seat post under the seat.
(9) Put the seat on the top of the seat post and lock the seat by tightening
the knob.
(10) Turn on the scooter and test the forward/reverse/stop functions to
ensure that it is working properly.
