15
Rev. 1.0
7/31/2019
SSDC-R/C/IP Hardware Manual
2.6 Connecting the Drive to Your PC using Ethernet
The RJ45 connector of SSDC-D/IP is conformed to 100BASE-TX(100Mbps).
Please use the CAT5 or CAT5e(or higher class) net cable.
This process requires three steps:
• Physically connect the drive to your network (or directly to the PC)
• Set the drive’s IP address
• Set the appropriate networking properties on your PC.
Addresses, Subnets, and Ports
Every device on an Ethernet network must have a unique IP address. In order for two devices to communicate with each
other, they must both be connected to the network and they must have IP addresses that are on the same subnet. A subnet
is a logical division of a larger network. Members of one subnet are generally not able to communicate with members of
another unless they are connected through special network equipment (e.g. router). Subnets are defined by the choices of IP
addresses and subnet masks.
If you want to know the IP address and subnet mask of your PC, select Start…All Programs… Accessories…Command
Prompt. Then type “ipconfig” and press Enter. You should see something like this:
If your PC’s subnet mask is set to 255.255.255.0, a common setting known as a Class C subnet mask, then your machine can
only talk to another network device whose IP address matches yours in the first three octets. (The numbers between the dots
in an IP address are called octets.) For example, if your PC is on a Class C subnet and has an IP address of 192.168.0.20, it
can talk to a device at 192.168.0.40, but not one at 192.168.1.40. If you change your subnet mask to 255.255.0.0 (Class B)
you can talk to any device whose first two octets match yours. Be sure to ask your system administrator before doing this.
Your drive’s IP Address is stored internally in nonvolatile memory. There is a rotary switch to set the IP address. The default
addresses are in below table.
