Page 22
For HELP, call 727.573.9611
1. Turn on the breaker and test the operation of the Ground-Fault Circuit
Interrupter (GFCI) breaker by pushing the small button. This should
automatically trip the hot tub's circuit breaker.
DANGER:
If this breaker does not trip, immediately call your electrician.
Do not use your hot tub!
Only if pushing this button successfully trips this circuit breaker should you
reset this breaker and proceed to the next step.
2. Go to the topside control panel. The hot tub first goes into a 5-minute
Priming mode, indicated by “Pr” message. Water heating is disabled during
priming. To exit Priming mode and begin normal hot tub operation, press
“Up” or “Down” button.
3. Press the Jets button. You should hear the pump turn on, see water
circulating, and see the Jets light illuminate on the panel.
4. Press the Jets button again. You should hear the pump turn on a higher
speed.
Caution:
If water is not flowing from the jets after 2 minutes, turn the
power off at the main panel and bleed air from the system (see
page 28). Turn the power on again. Sometimes momentarily
turning the pump off/on will help to prime. Only do this four
times.
5. If the water is running smoothly through the lines, open the air control valve
to the jets and you should see an increase in jet pressure. Check and adjust
the water and airflow of every jet if necessary.
Each jet in your hot tub can be adjusted for massage intensity and
directional flow. Turn the outer jet dial counterclockwise to increase the
water volume and clockwise to turn it off. Pivot the angle of a jet to achieve
an optimal massage.
An air mixture intensifies the level of your massage. Turn the air control
valve counterclockwise to increase the air mixture and clockwise to turn it
off.
To minimize heat loss, close the air control valve when the hot tub is not in
use.
6. Press the Jets button a third time to turn off the pump.
Note
: The pump remains on if filtration or heat is needed.
7. Press the Light button to turn on the light. Verify that the light is on.
8. Press the Light button a second time to turn off the light.
9. If equipped, press the Blower button. You should hear the blower turn on,
see water bubbling, and see the blower light illuminate on the panel.
10. Press the Blower button again to turn off the blower.
Summary of Contents for ML 736
