MiND
Nēo
Series
18
MiND Hardware Reset Procdure
(Appendix C)
(1) Take note of your network settings in your MiND App (refer to the MiND Setup Guide procedure), since a
hardware reset will automatically reconfigure these settings back to their factory defaults.
(2) Power down the
Nēo MiND
using the rocker switch located on the rear panel
(1)
. It does not matter whether
or not you leave it connected to your network.
(3) Insert the tip of the paperclip into the rear panel little hole labelled "Reset"
(2)
. There is a small push switch just
beneath the surface of the back panel, and when you insert the paperclip properly, and push on the switch,
you'll feel it click.
Hold the switch down - do not remove the paperclip until after step #4!
(4) While the “Reset” switch is pressed down, power up the
Nēo MiND
using the rocker switch located on the rear
panel
(1)
. Do Not remove the paperclip!
(5) Wait approximately two seconds, then remove the paperclip. You will notice that the WLAN LED
(3)
continues
to flash. This is unrelated to the resetting of the unit, and is part of the normal boot-up process of the MiND.
In a similar manner, the front-panel blue LED will continue to flash until it finally goes solid blue.
(6) Once the front-panel blue LED stops flashing and stays on constantly, the MiND is fully booted up and ready
to use. At this point you may re-enter your network settings from step 1.
3
2
1
