PRESS
Fast press 2 times
Over drive
High beam
Flashing
Strobe
Standard
Low
Over drive
High beam
Standard
Low
SOS
Fast press
2 times
Fast press
2 times
PRESS
09
10
REMOTE SWITCH
www.moon-sport.com
copyright
2009-2017 Moon Sport Ltd. All rights reserved.
1. Press the power button to choose the modes:
In this button control four modes are cycling in loop.
2. Fast press the on / off button two times to change to the
flashing modes. Fast press two times back to the steady light
cycle.
Over drive
High beam
Standard
Low
3. Press and hold the on / off button around 1 second to turn off the light.
REMOTE SWITCH OPERATION
Equipped with an outer setting controller, you could get handy
with the light for brightness transferring into an approximate
power when riding. And it will be helpful for heat dissipation
and avoid any scalds occurrence when light working long and
getting hot.
1. Open the light tail cover.
2. Then plug in the controller wire.
3. Make sure it has been completely jointed.
1. Put one end of the belt go through the cycle handle bar
2. Align to the controller button and pass through.
3. Please pull the Velcro ends tightly.
1. Put one end of the belt go through the helmet hole.
2. Align to the controller button and pass through .
3. Please pull the Velcro ends tightly.
*When unused,please ensure the protective cap closed to
avoid water getting in.
REMOTE SWITCH OPERATION
REMOTE SWITCH MOUNTING
REMOTE SWITCH HELMET MOUNTING
Hold 1 sec.
Change mode
Turn off
PRESS
Never use the SOS sign unless there is a real emergency or danger
occurring. The SOS signal is visible for several miles. And the battery
can support for long runtime up to several hours.
!
