BEAM ADJUSTMENT
To adjust the horizontal beam, spin the headlight left to right for your
best side to side beam angle. To adjust the vertical beam angle,
loosen the mounting and rotate the light up and down to your best
vertical beam angle, then tighten the mounting.
MOUNTING THE HEADLIGHT
1. Insert the handlebar bracket into the bottom slot of the light;
2. Spin the below part of the bracket counter-clockwise to loosen the screw;
3. Unlock the bracket and put the light in suitable place of your handle bar;
4. Twist the screw clockwise to lock the bracket.
5. The bracket fits 22-35mm handle bar. Additional shims are included and
you can use them when necessary.
05
06
MOUNT THE HEADLIGHT ONTO HELMET
1. Remove the belt from one side of the helmet mount.
2. Place the helmet mount into the suitable location on helmet.
3. Wrap belt around helmet and attach the end of the belt to itself tightly.
4. Insert the headlight into the helmet mount until it clicks into place.
5. Press down release lever to remove.
To adjust the vertical beam angle when mounted on the helmet,
loosen the screw knob and rotate the light up or down to your
desired angle, then tighten the screw knob to hold the light in place.
The beam is widely dispersed, besides its high brightness. To prevent
from blinding the oncoming vehicles on the public roads, you’d better
adjust the angle downward.
!
INSTALL
click
ADJUST
INSTALL
RELEASE
HANDLE BAR MOUNTING
HELMET MOUNTING
www.moon-sport.com
copyright
2009-2017 Moon Sport Ltd. All rights reserved.
RELEASE
PRESS
RELEASE
LEVER
BELT
SCREW
KNOB
click
PRESS
PRESS
Copper plate LED board to increase the
LED heat transfer rate and enhance the
light performance.
