11
4) POWER / LED TEST
Using only the included
power supply, connect the
barrel end to the power sup-
ply input of your Werkstatt;
connect the other end to
an AC wall outlet (100-240
Volts AC / 50-60 Hz). At this
point, the red LED on the
front panel (LFO) should
begin blinking. If it does,
you’re ready to move on.
NOTE: Unplug the power
supply from the Werkstatt
before proceeding.
YOUR WERKSTATT IS NOW COMPLETE.
Place the 13 button caps on
the keyboard buttons.
Place the Top Panel in
position so that all of the
knobs, switches, and key-
board buttons pass through
the corresponding holes.
Secure the Top Panel using
the four (x4) black sheet
metal screws. The screw
holes in the Top Panel
should line up with the screw
holes in the Bottom Chassis.
NOTE: Tightening these
screws may require a little
extra effort the first time,
as these screws must cut
threads into the metal holes.
5) ATTACHING KEYBOARD BUTTONS
6) ADDING THE TOP PANEL
