- -
ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY):
Power 24VAC, Class 2 Only
26 watts at 24 VAC Heater and Blower
Heater: 25 watts
Blower: 1 watt
Input Connectors (outdoor units):
Camera Power, BNC
(2) screw-down connectors
NOTE:
This unit is designed for operation in an upright
position. Installing the QRH upside down may
cause damage to the internal equipment, and
will void the warranty.
Be sure the bracket is properly and securely mounted to a
supporting structure capable of rigidly holding the weight of
the entire unit.
TO OPEN THE HOUSING
1. Open the housing by loosening the (3) security screws
located on the housing ring next to the lower clear dome
(Figure 1).
Figure
1
INSTALLING THE HOUSING ASSEMBLY
FOR WALL MOUNT, QSD
A wall mount bracket comes standard with this unit, and a
template is included to use as a guide for mounting the bracket
to a wall. Choose the desired location for installation and mark
the drill holes using the template. Mount the wall mount bracket to
the wall with (4) bolts (not provided).
NOTE:
Be sure the hardware and the mounting surface can support
the weight of the wall mount bracket plus the weight of the
housing and drive unit. The load will be subjected to vibration
from the camera motor and wind.
2. The wall mount bracket provided with the rugged housing includes
a location for conduit entry. If you wish to install conduit to the
bracket remove the conduit hole plug. Install fitting from below the
wall mount and secure with conduit nut from inside the bracket.
GENERAL INSTRUCTIONS:
Tools Required: .100" Flat Head Screwdriver
Phillips Head Screwdriver
Toolhead driver (supplied)
CAMERAS VOLTAGE CURRENT POWER
1 24 VAC/VDC 102mA 2.5W
2 24 VAC/VDC 210mA 5W
3 24 VAC/VDC 331mA 7.9W
4 24 VAC/VDC 487mA 10.9W
Use the formula below to select the correct power supply for
cameras connected in parallel (positive to positive, negative to
negative):
Total current for a 4 VAC system:
TOTAL CURRENT = (0mA x total number of cameras)
Note: 202mA is camera plus power supply
CABLE AND POWER GUIDELINES
This chart shows the proper current needed for power supplies for
Q-View™ cameras. Use Class 2 Power only. Input voltage must
be 24 VAC/VDC.
