CAMERA ADJUSTMENT
1. Access the cameras by removing the dome. Loosen the locking screws on the lip of
the dome.
DO NOT TAKE THESE SCREWS OUT
. Once the screws are loosened, turn
the dome counter clockwise until it stops, then pull the dome off.
CAMERA FOCUSING (FOR EACH CAMERA)
Fixed Lens:
Loosen the set screw in the lens mount. Manually rotate the lens until a
clear picture is achieved. Once the focus is set, retighten the set screw
(Figure 5)
.
Figure 5
Set screw
Fixed lens
Auto Iris Lens:
NOTE:
THE AUTO IRIS LENS IS SET AT THE FACTORY.
• IF YOU EXPERIENCE VIDEO TOO LIGHT OR DARK AUTO IRIS ADJUSTMENT
MAY BE NEEDED.
SEE THE TROUBLESHOOTING SECTION FOR
ADJUSTMENT INFORMATION.
CAMERA SETTINGS
HIGH-RES BLACK & WHITE
FIXED AND FIXED VARI-FOCAL LENSES
. There are no user adjustable settings on
these units
(Figure 6)
.
Figure 6
AUTO IRIS LENSES
. The dip switches are factory set with AES off and backlight
compensation on
(Figure 7)
. The auto iris is also set at the factory, but an adjustment
screw is included for use if needed. See page 10 for instructions on adjusting Auto Iris.
Auto Iris
adjustment
screw
AES Default Off
Backlight
Compensation
Default On
Figure 7
BW Fixed and Vari-Focal
BW Auto Iris
NOTE: To determine which camera is used in your unit, locate the serial number on the
inside of the housing. Match the two letter prefix with the corresponding instructions
included here for adjustments.
