ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY):
Power 24Vac, Class 2 Only
26 watts at 24Vac Heater and Blower
Heater: 25 watts
Blower: 1 watt
Input Connectors (outdoor units):
Camera Power, BNC
(2) screw-down connectors
NOTE:
This unit is designed for operation in an upright position.
Installing the QRH upside down may cause damage to the internal
equipment, and will void the warranty.
Be sure the bracket is properly and securely mounted to a
supporting structure capable of rigidly holding the weight of the
entire unit.
TO OPEN THE HOUSING
1. Open the housing by loosening the (3) security screws located on the housing ring
next to the lower clear dome
(Figure 1)
.
Figure
1
INSTALLING THE HOUSING ASSEMBLY
PENDANT MOUNT
1. This unit includes a 1½" NPT coupling for a standard 1½" NPT pipe. The QSD
housing can be used with other brackets designed with 1½" male pipe threads, such
as the Moog Videolarm WM20G wall mount bracket.
2. Attach the housing coupling
(Figure 2)
.
NOTE:
Pipe threads should be clean and rust free. Use a sealer
(such as Teflon™
tape or silicone sealer)
on the threads.
GENERAL INSTRUCTIONS:
Tools Required: .100" Flat Head Screwdriver
Phillips Head Screwdriver
Toolhead driver (supplied)
CAMERAS VOLTAGE CURRENT POWER
1 24Vac/Vdc 102mA 2.5W
2 24Vac/Vdc 210mA 5W
3 24Vac/Vdc 331mA 7.9W
4 24Vac/Vdc 487mA 10.9W
Use the formula below to select the correct power supply for cameras connected
in parallel (positive to positive, negative to negative):
Total current for a 24Vac system:
TOTAL CURRENT = (202mA x total number of cameras)
Note:
202mA is camera plus power supply
CABLE AND POWER GUIDELINES
This chart shows the proper current needed for power supplies for Q-View™
cameras. Use Class 2 Power only. Input voltage must be 24Vac/Vdc.
Figure 2
Add thread sealing
tape
