- 7 -
Chart A Wiring Color Code
Power and Control Inputs
(Outside of housing)
POWER
1
Camera and Heater/Blower (12 VDC) Red
2
Camera and Heater/Blower (12 VDC) Black
ALARMS
1
Alarm 1
Blue
2
Alarm 2
Violet
3
Alarm 3
Gray
4
Common
White
DATA
1
RJ45 Ethernet Connector
RJ45 Ethernet Cable
Connect power plug to camera per camera instructions.
ALARMS
1
Alarm 1
Blue
2
Alarm 2
Violet
3
Alarm 3
Gray
4
Common
White
Set screws
Plastic Cover
MOUNTING THE HOUSING
1. Mount the housing assembly to the mounting bracket and housing
coupling. A safety cable is included to temporarily hold it while making
wiring connections. Loop the safety cable over one of the set screws on the
coupling and make the appropriate connections using the (2) screw-down
connectors supplied.
Chart B Power and Control Outputs
(Inside of housing)
CAMERA POWER
Connect power plug provided.
NOTE:
Center Pin + (White Wire +).
GENERAL INSTRUCTIONS
The PFD75C12N is setup with (1) power input.
1. Accessory Power (yellow and green wire)
Housing Power requires 42 watts (excluding camera)
A. Be certain that you know the total power consumption of housing Heaters
(40 watts) + Blowers (2 watts) + camera. Your transformer will need to be
sized accordingly.
B. Check the supplied wiring chart to be sure that you have the proper
gauge wire for the distance that you intend to run your power wires.
2. Undo the safety cable, twist the housing onto the housing coupling, and
secure all (3) setscrews provided on the coupling.
3. Clean the inside of the dome, with the text-wipe provided. Reattach the
housing dome and secure the (3) captive screws. Do not overtighten the
screws. Tighten only to the point at which the gap between the ring and the
housing top closes.
4. Clean the outside of the dome.
