5
MODEL: Brackets, Mounts, and Poles
PV4
Please read these instructions carefully before
proceeding, and heed all cautions.
STANDARD INSTALLATION PROCEDURE
Requires MODELS: PV4 Anchor Jig
NOTE: If you'll be using the optional PV4 anchor
jig, see the attached instructions for
assembly of the jig.
Anchor Jig Kit Parts List
Single Straps
(4)
Cross Strap
(1)
3/4" - 10 Bolts
(4)
3/4" Flat Washers
(4)
3/4" - 10 Hex Nut
(20)
Lock
Washers
(4)
1. Thread two (2)
nuts
onto each of the (4)
bolts
(Figure 1). The
end with 6" of clearance will be the top of the
Anchor Jig
, the
end with 1 1/2" clearance will be the bottom.
NOTE:
Because of surface conditions it may be necessary to use
leveling nuts. See step 5 below for information.
NOTE:
The
Flat Washers
,
Lock Washers
, and remaining
Hex
Nuts
will be used to fasten the pole to the
Anchor Jig.
4. Before using the
Anchor Jig
verify that the center to center
dimensions between the bolts are even (Figure 4). If not,
adjust accordingly. Firmly tighten all
Hex Nuts
.
With Leveling Nuts
Without Leveling Nuts
Figure 1
2. Place the short end of each
Bolt
into the outside holes of the
Cross Strap.
Place
Hex Nuts
onto each
Bolt
and
fi
nger
tighten (Figure 2).
3. Turn the
Anchor Jig
over and place
Single Straps
over the
Bolts
(Figure 3). Use the inside hole of each strap. Place
Hex Nuts
onto each
Bolt
and
fi
nger tighten.
3
e
r
u
g
i
F
2
e
r
u
g
i
F
Figure 4
5. If, due to conditions or other requirements, leveling nuts are
needed, adjustments will have to be made to the
Anchor Jig
.
Below are diagrams comparing the
Anchor Jig
with and
without leveling nuts. Leveling nuts and washers are NOT
provided with the pole,
!
!
1
1
/
2
"
6"
18"
7
25
/
32
"
7
25
/
32
"
11"
diameter
I. Pole Installation Instructions
