- 2 -
A. Wiring Color Code
Power and Control Inputs
(Outside of housing)
1 Camera Power (24 VAC) Red
2 Camera Power (24 VAC) Orange
3 Accessory Power (24 VAC) Yellow
4 Accessory Power (24 VAC) Green
1 RS-485RXA Blue
2 RS-485RXB Violet
3 RS-485TXA Gray
4 RS-485TXB White
1 Camera Power (24 VAC) Red
2 Camera Power (24 VAC) Orange
3 RS-485RXA Blue
4 RS-485RXB Violet
5 RS-485TXA Gray
6 RS-485TXB White
POWER
CONTROL
POWER AND CONTROL LEADS
B. Power and Control Outputs
(Inside of housing)
4. Connect the Pan/Tilt base to the quick-release bracket by sliding
the slots on the top of the base over the screws on the quick-
release bracket. Tighten the screws to secure the base to the
bracket (Figure 4).
Figure 4
Place slots
over screws
in quick-
release
bracket
MOUNTING THE HOUSING
1. Mount the housing assembly to the mounting bracket and
housing coupling. A safety cable is included with the housing to
temporarily hold it while making wiring connections. Loop the
safety cable over one of the set screws on the housing coupling
2. Make the appropriate connections using the (2) screw-down
connectors supplied. Refer to Chart A as a guide.
3. Undo the safety cable and twist the housing onto the housing
coupling. Secure all (3) set screws provided on the housing
coupling (Figure 7).
5. Attach the safety cable on the bottom of the camera onto the slot
on the Pan/Tilt base (Figure 5).
Figure 5
6. Attach the Six Position Pan/Tilt Connector from the camera to the
Pan/Tilt base (Figure 6). Connect the dome camera to the Pan/Tilt
base by aligning the notch on the Pan/Tilt base with the arrow on
the camera, and turning the camera clockwise until it locks.
Figure 6
Six Position
Pan/Tilt
Connector
7. Clean the inside of the dome with the text-wipe provided. Reat-
tach the housing dome and secure the (3) captive screws. DO
NOT OVERTIGHTEN THE SCREWS. Tighten only to the point at
which the gap between the ring and the housing top closes.
Figure 6
4. Clean the outside of the dome with the text wipe provided.
Twist and
Secure
WIRING FOR INDOOR UNITS
1. Run incoming wiring into the top of the housing and through the
hole in the center of the quick release bracket. (Figure 7).
2. Attach the housing to the pendant coupling.
3. Connect the wiring to the Pan/Tilt base per Toshiba's instructions.
Figure 7
Center
hole
