- -
WIRING to Camera - 24VAC CAMERA UNITS
Inside of Housing
1. For 24Vac units, the power board that is located in the base
of the unit is not needed.
2. To remove the power board start by loosening the screws
on the terminal block and disconnect the orange and red
wires.
3. With a Phillips head screwdriver remove the (4) machine
screws holding the power board to the base bracket.
Machine screws (4)
Base Bracket
4. Red and orange wires will provide 24Vac power to camera.
WIRING to Camera - 12VDC CAMERA UNITS
Inside of Housing
1. The internal power supply provides 12Vdc power.
2. Plug in right angle power plug to back of camera;
plug provides 12Vdc to camera.
Make all connections
to the camera.
+
–
12DC
WIRING to Camera - 18VDC CAMERA UNITS
Inside of Housing
(JVC VNC655 CAMERA)
For the JVC VNC655 camera
the jumper on the power
board must be set to open.
This provides 18Vdc to the
camera.
NOTE:
Housing is set at 12Vdc
from factory.
!
Power supply from factory
is set with 12Vdc as the
default. You
must
move
the jumper to set output
for 18Vdc.
ALARMS
1
Alarm 1
Blue
2
Alarm 2
Violet
3
Alarm 3
Gray
4
Common
White
WIRING to Camera - ALL CAMERA UNITS
Inside of Housing
1. Complete connector for network and video (if required).
2. An additional 4 feedthrough leads are provided and may
be used for alarm wiring (see chart below).
