!
Product InstructIons
rEVIsIon dAtE: June 8, 2005
81-In5313
FdW8cs
ELEctrIcAL sPEcIFIcAtIons (outdoor):
Power 24VAC, Class 2 Only
55 watts at 24 VAC
27 watts for heater and blower
25 watts for camera
Optional heater/blower assembly: CWKFD2 - 24 VAC cold weather
kit for outdoor FDW(P)8C2 housings
Input Connectors (outdoor units):
BNC
(2) screw-down connectors
dEscrIPtIon:
The FDW8CS is a 24 VAC outdoor housing enclosure constructed
of .125 engineered plastic, aluminum and stainless steel. All plastic
components are designed to be UV stable; the housing top is rated
at 94VO. The FDW8CS measures 11.5" (w) x 12.9” (h) x 16" (d), with
a weight of 7 lbs.; measurements for the FDP8CS are 11.5" (w) x
12.9" (h) x 11.5" (d), 7 lbs. Flying leads are provided for all incoming
power, control, and video connections. The leads are supplied with
a standard BNC and (2) screw down connectors. A 25 watt heater
and a circulation blower are also provided. To service, remove the
lower dome and ring assembly.
notE:
This unit is designed for operation in an
upright position. Installing the FusionDome™
upside down may cause damage to the
internal equipment, and will void the war-
ranty.
GEnErAL InstructIons:
Tools Required: .100" Flat Head Screwdriver
Phillips Head Screwdriver
1.
FdW8cs
A wall mount bracket comes standard with this unit, and a
template is included to use as a guide for mounting the bracket
to a wall. Choose the desired location for installation, mark
and drill holes using the template. Run approximately 8" of wiring
out of the wall.
2. Open the access door on the bottom of the wall mount by
loosening the screw nearest the mounting plate (Figure 1).
3. Run the wires into the opening on the back of the mount and out
through the access door. Attach the mount and housing to the
wall
with appropriate hardware (no provided).
4. Attach the wires from the wall to the connector provided, using
the
wiring color code chart on page 2 as a guide.
5. Once all wiring connections are made, place the wires inside the
wall mount bracket and close the access door. Secure with the
screw removed earlier.
6. Clean the outside of the dome.
InstALLInG tHE HousInG AssEMBLY
For WALL Mount, FdW8cs
Figure 1
Access door
tABLE oF contEnts
description
1
Electrical Specifications (Outdoor)
1
Installing the Housing Assembly
1
Preparing Pendant Mount FDP8CS
2
Installing Pendant Mount Housing
2
Wiring Color Code Chart
2
Wiring Gauge chart
2
setting Protocol for the unit
3
Setting the Address for the Unit
3
optional settings for the s View 2™
3
Menu driven settings
3
dipswitch settings
5
Exploded View
9
Safeguards and Warranty Information 10
Mounting template
11
Unitized Pan/Tilt/Zoom
in Fusion dome
