- 3 -
- 3 -
INSTALLING QUICK RELEASE BRACKET AND
PAN/TILT CAMERA ASSEMBLY (ALL MODELS)
1. Open the housing by loosening the screw on the front of the dome
trim ring (Figure 1). Note the arrows and the word "Locked" on the
side of the housing and trim ring. Rotate the trim ring until the
bottom arrow aligns with the second top arrow, then pull the dome
and trim ring off.
Figure 1
!
DESCRIPTION:
The FDW7 Housing is a Vandal Resistant Housing especially de-
signed for integrated pan/tilt units. The housing top is made of high
impact Lexan
®
while the lower dome is made of an optically clear,
UV stable, polycarbonate plastic. The FDW7 housing measures
10” (w) x 13 (h) and 14.75” (d) with a weight of 8.25 lbs. Flying
leads are provided for all power, control and video connections. The
leads are supplied with a standard BNC and (2) screw down con-
nectors. A 25W heater (25 watts total) with a circulation fan is also
supplied.
ELECTRICAL SPECIFICATIONS (OUTDOOR
ONLY):
Power 24VAC, Class 2 Only
26 watts at 24 VAC (accessories)
Heater: 25 watts
Blower: 1 watt
Input Connectors (outdoor units):
BNC
(2) screw-down connectors
NOTE:
This unit is designed for operation in an upright
position. Installing the FDW7 upside down may
cause damage to the internal equipment, and
will void the warranty.
Be sure the bracket is properly and securely mounted to a
supporting structure capable of rigidly holding the weight of
the entire unit.
GENERAL INSTRUCTIONS:
Tools Required: .100" Flat Head Screwdriver
Phillips Head Screwdriver
!
2. Install the pan/tilt unit quick-release bracket.
It is recommended
that this be done before installing the housing
. Instructions for
mounting quick-release brackets from selected manufacturers are
on page 4.
3. Clean the inside of the dome and reattach.
Do not overtighten
the screw
. Tighten only to the point at which the gap between the
ring and the housing top closes.
