![background image](http://html.mh-extra.com/html/monzana/deuba-108113/deuba-108113_installation-and-operating-instructions-manual_1831185018.webp)
18
www.DeubaXXL.de
1.Main Power ON/OFF
This switch Controls the electricity supply to the
heater and flame effect.Put the switch to ON (”I”) position.
Note:
This switch must be in the ON (I) position for fireplace to operate with
or without heat.
2.Powering the Fireplace
Push the Power button to supply power to all functions of of the fireplace and
put the fireplace in a standby mode.
-ush the Power button again to turn off all functions.
Note:
All previous settings are held in memory, so the next time you power up
the fireplace, the unit will turn on with the same settings
3.Adjusting the Heater
Turns the Heater On and Off, actived by pressing the
button on the remote
or control panel. Cycles the unit through the three settings:
•
‘H2’, High Heat. Indicated icon
on display.
•
‘H1’, Low Heat. Indicated icon
on display.
Blower and Heater OFF, Indicated icon is off.
4.& 5.
Adjusting the thermostat
•Press the Thermostat button
on the control panel to change the setting
temperature.
•The thermostat setting range is 15°C- 30°C.The default temperature setting is 25°C
•The thermostat is adjustable by 1°C incremen ts by pressing the Plus or Minus “
“
buttons (7&8) on the remote control or buttons
on control panel.
6.
Flame Picture ON/OFF
•
Press the Flame Picture button on the control panel or remote control switch
ON or OFF the Flame Picture
0
I