22
UTILIZATION OF THE SYSTEM
STEPS TO FOLLOW TO CHARGE THE BATTERY PROPELY:
1. Make sure the contact key to be in position “OFF”.
2. Connect the plug to the electric system.
3. To initiate the charge, push the Red button from the rear side of the covering.
4. The light led indicate the position level of the charge.
5. To stop the charging, push again the Red button
6. take out the plug from the electric system
Figure 15 Figure 16 Figure 17 Figure 18
MEANING OF THE LIGHTS ( LEDS ):
RED LED MEANS: The charger is connected to the electric system
+ YELLOW LED : The charge is being charged (Figure 16)
+ GREEN LED: The battery is already charged (Figure 17)
+ OFF LED: The charger is disconnected (Figure 18)
ATTENTIÓN: The charger is equipped with a safety fuse of 10A, in case that the charger it not work, che
charger did not work, check the state of the fuse and change it if it were
necessary
12. ELECTRIC COMPONENTS
CONTROLLER
DPIE 3 controller is the nerve centre of the system. It consists of a small box placed
under the battery compartment and where all the components are connected.
The controller receives all the necessary information from the brakes, engine, battery,
etc.
The controller is responsible of the engine to work correctly and the DPIE 3 safety as
well.
The controller checking/handling requires specific tools and know-how. Only an
authorized dealer or the Monty plant should manipulate it.
ENGINE
DPIE 3 is provided with a top-quality, resistant engine.
The engine is part of the front
wheel, designed to provide a maximum service with barely any maintenance. The engine
Summary of Contents for DPIE 3
Page 1: ...DPIE 3 USER S MANUAL...
Page 2: ...2...
