When drying large items such as sheets, we suggest you periodically stop the dryer
to redistribute the load. To stop the machine during a programme, simply open the
door, the drum will stop rotating automatically and restart when you close the
door. Press the start button to restart the machine.
WARNING:
Never stop a tumble dryer before the end of a drying cycle unless all items are
quickly removed and spread out so the heat is dissipated.
•
Failure to clean the filter will extend drying times and cause the safety cut-out to
operate.
•
Pull the filter upwards and away from the appliance.
•
Remove threads or fluff by hand or with a soft brush.
•
Slide the filter back.
•
Wash the filter occasionally in detergent solution and with a soft brush to remove
small particles.
If the clothes are not dry after normal drying time:
•
Check that you have used the correct heater setting.
•
Check the fuse in the moulded plug.
•
Check that the lint filter has been cleaned. A blocked filter will restrict the airflow.
•
Check that your dryer is heating – The right side below the door should feel warm
after the first 10-15 minutes of its programme. Failure to heat may indicate the
safety cut-off has operated. To reset, simply press the red button at the rear of the
machine. If operated, a sharp click will be heard. This cut-off only operates if the air
flow is severely restricted so make sure the filter is clean, the air inlets and outlets at
the front and back are not blocked, and that all other restrictions are removed
before re-starting. If the cut-out continues to operate after checking the above
points, you should contact your service agent on
03333 234 473.
Your dryer is designed to operate in a room temperature range of 5°c to 30°c
NOTE: NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM –
RISK OF FIRE!
AFTER REMOVING THE DRIED CLOTHES: ALWAYS CLEAN THE FILTER.
TO AVOID MINOR FAULTS:
