INSTALLATION:
The tumble dryer is fully compatible with any 600mm deep kitchen units and complies
with stringent EEC regulations.
Your dryer is provided with a vent hose which will extend to approx. 2.4m (8ft). We
strongly recommend that this is vented through the wall with the attachment provided.
The position of the hole (100mm diameter) for the vent directly behind the tumble dryer
is shown in the diagram.
If the through the wall vent is to be positioned other than behind the dryer, the vent
hose should be positioned at floor level and through adjacent side panel to a relevant
position. The plinth must be cut-out to accommodate the air vent grill at the bottom
front of the tumble dryer.
IMPORTANT:
The air vent at the front of the appliance must never be covered or blocked in any way
as this will cause the dryer to overheat.
This appliance must not be installed behind a lockable door, a sliding door or a door
with hinges on the opposite side to that of the tumble dryer.
The dryer should not be installed behind a lockable door, a sliding door or a door
with hinges on the opposite side to that of the tumble dryer.
ELECTRICAL CONNECTIONS:
We strongly recommend that any electrical work is
carried out by a qualified person complying with the IEE 17th addition of the
electrical regulations.
IMPORTANT:
Please remember that the tumble dryer must be capable of being switched off,
(disconnected from the supply), when fitted in position.
