montpellier M603DDAP, Installation And Operating Instructions Manual

Page: 8 / 17

7
Section 2. Safety Advice
 Please read this booklet thoroughly before installing and switching on the
appliance. The manufacturer accepts no responsibility for incorrect installation
and usage.

If this appliance is to replace an old refrigerator with a lock, as a safety measure
break or remove the lock and/or door before disposal.
 Your old appliances contain insulation gases and refrigerant that must be
disposed of correctly. Please ensure that the refrigerant circuit is not damaged
before the appliance is taken away for correct disposal in line with current
legislation. If there is any doubt contact your Local Authority for instructions.

This appliance may contain the refrigerant isobutene (R600a). This is a natural gas
with a high level of environmental compatibility; however, caution is required as
isobutene is a flammable gas. It is essential to ensure that refrigerant tubes are not
damaged during transportation and the installation of the appliance. In the event
that the refrigerant circuit is damaged, avoid naked flames or sources of ignition and
ventilate the room in which the appliance is situated.

Do not damage the refrigerant circuit.

The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.

If using an adaptor, this must be used in accordance with the manufacturers
instructions and ensure that the electrical circuit is not overloaded as this could
cause overheating.

Do not twist or bend the cables, and keep them away from hot surfaces.
 Do not plug ın or unplug this appliance with wet hands.
 Following installation make sure that the power cable is not trapped underneath
the appliance.
 Ensure the appliance is left in an upright position for at least 4 hours before you
switch it on.

The plug supplied with this appliance must be fitted with a 13 Amp fuse.

If the power supply cord is damaged, it must be replaced by the manufacturer,
it’s service agent or similarly qualified persons in order to avoid a hazard.