montpellier M603DDAP, Installation And Operating Instructions Manual

Page: 6 / 17

5
Section 1. Installation

IMPORTANT! This appliance must be left to stand in an upright position for at
least 4 hours before being switched on for the first time.
 This appliance has been designed for Domestic Use Only.
 Remove all packaging and securing tape from the appliance.
 The exterior stainless steel surfaces may be covered with a protective film which
should be removed prior to use. Carefully peel the film from the surfaces and
then clean any marks left on the surface with a dry cloth.
DO NOT USE A
BLADE OR SHARP IMPLEMENT TO CUT or REMOVE THE FILM as this will
damage the surface of the stainless steel. Damage to the stainless steel surface
is not covered under the 2 year guarantee offered with this appliance.

Wash the interior of the appliance with luke warm water containing a small
amount of bicarbonate soda (5ml to 0.5 litres of water).

Position the appliance in a dry atmosphere and out of direct sunlight.

Do not position next to a cooker or other sources of heat, i.e. radiator.
 This appliance should not be sited in a cold atmosphere, i.e. garage or
shed. Doing so may cause the freezer unit to underfreeze.

If positioned next to another fridge or freezer, leave a minimum gap of 10cm
between the appliances in order to avoid condensation.

A clearance of 30mm should be left above the appliance. If this cannot be
achieved you should ensure a clearance of 20mm is maintained on each side of
the appliance.
 You must ensure a clearance of at least 10mm between the appliance and the
wall.
 Do not place or store heavy items on the top of this appliance.
 Ensure that the appliance is positioned on a firm flat floor.
 This appliance must be level. Adjust the level by using the leveling facility at the
base of the appliance.

Ensure that the appliance is upright and in firm contact with the floor so that the
cabinet is stable.

Connect the plug to an adjacent 13amp socket outlet and ensure that the
appliance is not standing on the supply cable.
 Ensure the appliance has sufficient air circulation as follows: