Before inserting the hob into the work surface, place the adhesive seal
“s” around the underside edge for the hob. It is important to fix this
gasket evenly, without gaps or overlapping to prevent liquids from
seeping underneath the hob.
1. Place the gasket around the bottom edge of the hobs as shown in
the illustration on the next page.
2. Place the hob in the installation opening and push it down so that
the hob is resting firmly on the cabinet.
3. Secure the hob in position using the fixing brackets supplied.
Secure the hob to the underside of the worktop using the fixings provided. Screw one end of the bracket
into the pre-drilled holes in the underside of the hob. The other end of the bracket should be located
underneath the worktop to secure the hob in position.
Note 1:
The minimum height of any adjacent units (including light pelmets) is 450mm, unless they are
manufactured from a material resistant to fire (steel, ceramic tiles for example).
Note 2:
No overhanging surface or range hood and exhaust system are not permitted within 750mm above
burner tops.
Note 3: Leave at least 50 mm clearance between the base of the appliance and a combustible
surface. Never leave the packing components (plastic bags, nails, foamed polystyrene, etc.) within the
reach of the children since they are a source of potential danger.
The hob has a special seal which prevents liquid from entering the cabinet. Follow these instructions in
order to correctly apply this.
Seal:
Detach the seals from their backing that the transparent protection still adheres to the seal itself. Turn
over the hob and correctly position seal under the edge of the hob itself, so that the outer part of the
seal itself perfectly matches the outer edge of the hob. Evenly and securely fix the seal to the hob,
pressing it firmly in place.
CLEANING AND MAINTENANCE
-Do not use cleaning products containing abrasive materials for the cleaning and maintenance of the
glass front panel.
-When cleaning do not use cleaning agents with a strong abrasive effect, such as e.g. scouring
powders containing an abrasive, abrasive compounds, abrasive stones, pumice stones, wire brushes
and so on. They may scratch the hob surface, causing irreversible
damage.
-Large spillages that are firmly stuck to the hob can be removed by a special scraper (not include); but
be careful not to damage the ceramic hob frame when doing this.
Caution!
The sharp blade should always be protected by adjusting the cover (just push it with you thumb). Injuries
are possible so be careful when using this instrument-keep out of reach of children.
Appropriate light cleaning or washing products are recommended, such as e.g. any kind of liquids
emulsions for fat removal. Alternatively a solution of warm water with a little washing up liquid or
cleaning products for stainless steel sinks can be used.
Summary of Contents for CKH61
Page 9: ......
