Cleaning:
Turn off the mains to the equipment before carrying out any maintenance and wait for it cool down. We
advise using lukewarm water and detergents to clean enamelled elements. Never use abrasive products.
Rinse the glass worktop with water and dry using a soft cloth. Use sponges or a moist cloth to clean the
tops, and remember that water in excess can damage the electric elements. Clean tough stains using
non-abrasive detergents, or warm vinegar.
Clean the electric tops using a moist cloth, then lightly oil the top when it is still warm.
Only licensed repairers should service the appliance.
Installation
Electrical connection Appliances with three-pole cable are set up for operation with alternating current
at the voltage and frequency indicated on the rating plate. Look at the connection wiring diagram. The
earth conductor is yellow/green.
The connection to the electricity supply must be made by a qualified person and following the regulations in force.
When the appliance is to be installed above a built-in oven, the two appliances must be connected separately.
The supply cable must be so positioned that no point can reach a temperature 50°C higher than ambient temperature.
Also check that the supply system has an effective earth connection and corresponds to the standards in force and
that the breaker can be reached easily when the appliance is installed.
Fitting guidelines
The voltage rating of the hob heating elements is 220-240V .Appliance with three-pole cable are set
up for operation current at the voltage and frequency indicated on the rating plate Look at the connection
wiring diagram. The earth conductor is yellow/green. The connection to the electricity supply must be
made by a qualified person and following the regulations in force. When the appliance is to be installed
above a built-in oven, the two appliances must be connected separately, to make it easier to take the
appliances out and for electrical safety.
If the appliance you have purchased is not fitted with a mains power lead a power lead resistant to a
temperature of at least 90°C must be used. Otherwise, the electrical safety lf the appliance may be put at risk.
The manufacturer declines all responsibility for damage to persons or things caused by non-observance
of the above prescriptions or by interference with any part of the appliance.
Summary of Contents for CKH61
Page 9: ......
