ENGLISH
16
6
13
14
15
16
ELECTRIC POWER SUPPLY
WARNING!
• Check the integrity of the cable and breakers.
• Respect the voltage (V) and frequency (Hz) indicated on the machine.
• Carry out the electrical connection with ground (yellow/green) to an IP67
outlet (2P+T) protected by an I∆N 0.01A differential breaker.
• Periodically check the operation of the differential breaker.
• For an extension, use only the IP67 (2P+T) socket and plug and a 3 x
2.5mm2 cable of the H 07 RN-F type (max length 5 m).
• Check the placement of the power cable: it must not obstruct movement,
and should not be subject to shock or damage.
• Remove the electrical connection during each routine or extraordinary
maintenance operation, for the loading of coolant (water), or for the sub-
stitution of the diamond disk.
• Models equipped with a thermal protection switch and minimum voltage coil.
• Avoid forcing the motor during processing. The machine has a security system that protects it from
engine overheating; consequently, if the motor is arrested without apparent reason, it is necessary
to wait a few minutes so that the safety circuit is disactivated, as the machine has almost certainly
been subjected to excessive force and the cutting advancement speed must therefore be moderated.
• IP55 single phase engine with electromagnetic emissions below the provided limits.
• In the case of malfunction regarding a breaker, cable, engine, or pump, consult an expert or our
Technical Office.
Level H
2
O: 8 cm
Level H
2
O: 8 cm
