EDVRSPV Vertical Power Vent System
Part No. XG1302 - 101201.2
f i r e
f e a t u r e
CAUTION!
Due to its high operating temperatures, the appliance
should be located in a well ventilated area / space. See
the clearancespecifications on Page 8.
Children and adults should be alerted to the haz
-
ards of the high surface temperature, which could
cause burns or clothing ignition.
Young children should be carefully supervised
when they are in the same room as the appliance.
Clothing or other flammable materials should not
be placed on or near the appliance.
Introduction
Before You Begin
■ Minimum clearances 1” from vent to all combustible
materials must be maintained. Clearances listed in the
fireplace’s Installation Operation and Maintenance Instruc
-
tions supersede this number.
CAUTION
:
When cold air enters the warmer building interior, primarily
at the air intake end, condensation may occur on the exterior
of the flex pipe. To limit this condensation, install insulation
over the last twenty feet of flex pipe. Also, by sloping the last
20'-0" feet of flex pipe downward toward the exterior of the
building, elimination of most of the condensation problems
should occur. Ensure the termination is securely fastened,
and sealed to the flex pipe. Fasten the termination to exterior
of the building with water tight sealant and the appropriate
fasteners.
General Information
This installation guide covers installation of the External Power
Vent System only. This system is designed to allow installation
of gas fireplaces that cannot be done with a standard Direct Vent
gas fireplace installation.
Also, read through the fireplace's Installation Operation and
Maintenance Instructions, as it must also be adhered to.
Power Cord Harnesses:
EPVH10 -10 foot power cord and harness
EPVH20 -20 foot power cord and harness
EPVH40 -40 foot power cord and harness
EPVH60 -60 foot power cord and harness
EPVH80 -80 foot power cord and harness
EPVH100 -100 foot power cord and harness
Selecting and Installing the
Fireplace
When selecting a gas fireplace for use with the External Power
Vent System, take into consideration the various requirements
and limitations in the
venting installation section
for the following
models:
Models Equipped with Electronic Ignition
It is recommended that this system be used with a gas fireplace
equipped with a Hot Surface Ignition System. Because there
is not a pilot in this system, there is more flexibilty on venting
requirements. For example downward vertical vet runs are pos
-
sible with an HSI system, as outlined in the
Venting Section.
Installation
Page 3