Montgomery Ward SG775185, Instruction Manual, Page: 5 / 8

1
•
888
•
557
•
3848 wards.com
8 9
How to Use (cont.)
ADJUSTING THE CUT ANGLE
1. Loosen the miter lock screw.
2. Tilt the base plate and use the scale to
adjust the cutting angle to the desired
angle between 0° and 45°.
3. Retighten the lock screw.
4. Follow steps for saw operation on page 7.
5. We recommend doing a
trial cut to test the
angle before cutting into your workpiece.
USING THE PARALLEL STOP
1. Loosen the parallel stop lock
screw.
2. Adjust the parallel stop to
desired distance using the
scale.
3. Retighten the lock screw.
4. Align the parallel stop with the
guide edge of material.
5. Follow steps for saw operation
on page 7.
6. We recommend doing a
trial cut
to test the measurement before
cutting into your workpiece.
ADJUSTING THE CUT DEPTH
1. Release the cut depth lock screw.
2. Swing the base plate downward.
3. Adjust the cut depth using the scale.
4. The saw teeth must project at least 2mm
through the thickness of the workpiece.
5. Retighten the lock screw.
6. Follow steps for saw operation on
page 7.
7. We recommend doing a
trial cut to test
the depth before cutting into your workpiece.
Miter Lock
Screw
Miter
Scale
Parallel Stop
with Scale
Parallel Stop
Lock Screw
Base Plate
Hinge
Cut-Depth
Lock Screw
Cut-Depth
Scale
Cleaning & Care
1. Turn off and unplug the power tool.
2. Always allow it to cool completely before cleaning.
3. Keep vents clean and unobstructed at all times. Blow out any dust and dirt at
regular intervals.
4. Never use any caustic agents to clean the plastic tool parts.
5. DO NOT use abrasive brushes or pads, or harsh cleaning solutions.
6. Wipe down the exterior of the tool with a clean cloth (beware of sharp points
and edges).
7.
DO NOT immerse any electrical tool, cord or plug into water.
8. Store tools in a dry environment, out of reach of children.
Base Plate
Hinge