Montgomery Ward 769117, Instruction Manual

Page: 6 / 9

1
•
888
•
557
•
3848 Wards.com
10 11
How to Use
POWER turns the unit ON/OFF.
UP ( + ) and DOWN ( - )
increases/decreases temperature settings.
MODE
1. COOL: press UP and DOWN to select desired temperature (62˚ F–86˚ F). To
convert from C to F on the display, press and hold UP and DOWN at the same
time, for 3 seconds. Press FAN speed button on the remote controller to choose
the fan speed (auto, low, high or medium). The exhaust hose should be vented
out the window. Press POWER to start.
2. DRY (dehumidify): press UP and DOWN to select desired temperature (62˚–
86˚ F). The fan speed operates at low (and cannot be changed). Keep windows
and doors closed for the best results. Remove exhaust hose from window. Attach
the drain hose (see page 8). Press POWER to start.
3. FAN: Selects the
fan only (no cooling). Press the FAN speed button on the
remote controller to choose the speed. The temperature cannot be adjusted.
Remove the exhaust hose from the window. Press POWER to start.
FAN
controls the fan speed in COOL and FAN MODES. Press FAN to select low,
medium, high or auto.
LED DISPLAY
shows the set temperature on COOL mode. While on DRY and FAN
modes, the room temperature is shown.
SLEEP/ECO:
(on remote control only)
The set temperature will increase by 2° F in 30 minutes. The set temperature
will then increase by another 2° F after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it returns to the original setting.
The unit will then operate as originally programmed. This feature is not available
under FAN or DRY modes.
SHORT CUT BUTTON
(on remote control only)
1. Press SHORT CUT when the unit is ON, and the settings will revert to the
previously set options, including mode, temperature setting, fan speed and sleep.
2. Press SHORT CUT more than 2 seconds, and the current settings will be restored.
TIMER ON/OFF
(on remote control only)
1. Press TIMER ON repeatedly to select the time (in hours) you want the unit to
start.
2. Press TIMER OFF repeatedly to select the time you want the unit to turn off.
3. Turn off either function by setting to “0.0h.”
LED (on remote control only) turns the LED display (on the unit ) on and off.
AIRFLOW DIRECTION ADJUSTMENT
is done manually by moving the horizontal
and vertical louver controls. Keep the louvers fully opened during operation.
AUTO-RESTART
will occur if the unit breaks off unexpectedly due to power going
out. The unit will restart with the previous function setting automatically when the
power resumes.
Installation (cont.)
BOTTOM TRAY DRAIN OUTLET
1. When the water level of the bottom tray
is at maximum, the unit beeps 8 times
and the display shows P1. The air
conditioning/dehumidification process
will immediately stop, but the fan motor
will continue to operate.
2. Carefully move the unit to a drain
location, remove the bottom drain plug
and let the water drain.
3. Reinstall the bottom drain plug and
restart the machine. P1 will no longer
show on the display.
bottom tray
drain outlet
INSTALL THE DRAIN HOSE
1. During DRY (dehumidifying) mode,
connect the drain hose for proper
draining of water being removed from
the air.
2. Remove the cap from the drain outlet
on the back of the unit and securely
attach the drain hose.
3. Place the open end of the hose directly
over the drain area in your basement
floor.
drain
outlet