Montesa COTA 4RT RACE REPLICA, Owner'S Manual

Page: 143 / 168

5-27 5-27
Frame servicing
(1) BRAKE PADS
(2) PAD PIN
(1) CALIPER BRACKET
(2) BOSS/SLIT
Install the new pads and secure them with the pad pin.
Install the brake caliper bracket aligning its slit with the
boss on the swingarm.
Install the rear wheel (page 5-16).
Operate the brake pedal to seat the caliper pistons against
the pads.
(1) CALIPER PISTON
Remove the rear wheel (page 5-15)
Push the piston all the way in to allow installation of new
brake pads.
Check the brake fluid level in the reservoir as this operation
causes the level to rise.
Remove the pad pin and brake pads.
Clean the brake caliper inside especially around the caliper
pistons.
(1) BOLT
(2) SPEED SENSOR
(3) SPEED SENSOR BRACKET
Rear Brake Pad Replacement (ED / 2E) (ED / 2E)
NOTICE
Before replacing the rear brake pads, remove the speed
sensor.
The speed sensor may be damaged if struck or pulled.
Speed sensor removal
Remove the following:
– Speed sensor bolt
– Remove the sensor from the sensor mount.
Detach the speed sensor from the rear brake calliper for
easier removal.
2
1
2
1
3
2
1
ED / 2E ED / 2E ED / 2E ED / 2E
ED / 3E ED / 3E ED / 3E
ED / 2E ED / 2E
ED / 2E ED / 2E
ED / 2E ED / 2E
1