Monterey Boats 186MS, Owner'S Manual

Page: 95 / 254

95
MONTEREY
BOATS
EXTERIOR EQUIPMENT
11.1 Deck Equipment
Rails and Deck Hardware
The rail system and hardware fittings have been
selected and installed to perform specific func
-
tions. Hand rails are installed to provide a hand-
hold in certain areas of the boat. You should make
sure you keep at least one hand on the handholds
as you move about the boat.
Fenders or mooring lines should be secured to
the cleats and not to rails or stanchions. The
cleats on your boat are retractable and flush with
the deck when not in use. To use the cleats, pull
up on the center of the cleat until it locks in the
mooring position. Be sure a clear lead exists
when running dock lines or anchor lines. A line
inadvertently run around a stanchion or over the
rail could cause damage.
NOTICE:
All fittings must be inspected periodically for
loose fit or wear and damage. Any problems
should be corrected immediately.
WARNING
MONTEREY BOATS ARE NOT EQUIPPED WITH HARDWARE
DESIGNED FOR TOWING PURPOSES. THE MOORING CLEATS
ARE NOT TO BE USED FOR TOWING ANOTHER VESSEL OR
HAVING THIS BOAT TOWED.
Anchor/Rope Locker
The anchor locker is in the bow of the boat and ac-
cessed through a hatch in the deck or by removing
the forward bow seat cushion. The anchor line is
always stored in the rope locker and there is an
eye fitting to secure the bitter end of the anchor
line. Always make sure the rope locker deck hatch
or bow cushion are closed and properly secured
before getting underway.
If the anchor is stored in the anchor locker, it must
be properly secured to prevent it from bouncing
in the locker and causing damage to the hull or
anchor locker. Deck mounted anchor lockers are
designed for one fluke style anchor that is prop
-
erly secured in the cradle. Do not store additional
anchors or any heavy object in the anchor locker.
Chapter 11:
Retractable Cleat Deployed
Retractable Cleat Stowed
Bow Grab/Hand Rails