© 2011 Monte Carlo Fan Company
1/16/2012
3
Insert downrod into motor yoke. Next, insert
clevis pin through yoke and downrod and secure
with cotter pin. (see inset)
Before you begin installing the fan, Switch power off
at Service panel and lock service disconnecting
means to prevent power from being switched on ac-
cidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warn-
ing device, such as a tag, to the service panel.
Install canopy and yoke cover over the down-
rod.
1
4
6
Thread wire through downrod with canopy and
yoke cover assembled.
5
3
Outlet box
Wood
Screws
Mounting
Bracket
Secure mounting bracket directly to a joist from
the buliding structure. Use only the appropriate
wood screws and washers included with your
fan.
Caution
: Wood screws must go through
into the building joist.
Note
:If Installing It In The U.S., Do Not Remove
Knockouts In The Outlet Box
BUILDING
STRUCTURE
METHOD
Carefully lift fan assembly onto mounting
bracket. Rotate fan so that the notch on the
ball engages the ridge in the mounting bracket.
This will allow hands-free wiring.
8
7
Tighten both yoke set screws to further secure
downrod.
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod modes the safety cable must be installed
into the house structure beams using 3” lag
screws, washers and lock washers provided. Make
sure that when the safety cable is fully extended
the lead wires are longer than the cable and no
stress is placed on the lead wires.
Note
:If Installing The Secondary Support Safety
Cable in the U.S., Do Not Remove Knockouts In
The Outlet
9
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
Warning
-Risk of fire, electric shock, or personal in-
jury. The fan in this box may be either directly sup-
ported from a structural framing member of a
building and/or may be mounted to an outlet box
marked acceptable for fan support of of 31.8 kg (70
lbs) or less. Use only the hardware provided with
the fan brace or outlet box.Most outlet boxes com-
monly used for the support of lumminaires may not
be acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
Use only the hardware provided with outlet box.
2
OUTLET BOX METHOD
For Installation
in The U.S. only
