Monte Carlo Fan Company 5LDO52 Series, Owner'S Manual And Installation Manual

Page: 6 / 9

6
18 19
21 22
20
© 2022 Monte Carlo Fan Collections
3/2022
23
Install 2 of the screws to the side panel of
mounting bracket corresponding to the
open slotted holes on the canopy upper
rim, screws provided. Remove the thread
studs from the lower part of the mounting
bracket.
Lift fan to mounting bracket, aligning the
“L” shape holes on canopy with the
screws on the mounting bracket. Turn the
fan clockwise to lock in position. Install
the other 2 canopy mounting set screws
from the hardware pack and tighten all
screws securely.
Install blade bracket with blade by 3
blade screws and washers provided.
Tighten screws securely. Repeat this
process for remaining blades.
Note
: Make sure the side with a mark
“This side up” is installed upward.
Remove shipping stabilizers from motor
assembly.
Install the blade assembly to motor using
the preinstalled screws. Tighten screws
securely. Repeat this process for
remaining blade assemblies.
Remove the set screws from switch
housing cap on top of light fixture. Keep
screws.
Connect light lead wires. White to white,
blue (or black) to black (or blue). Make
sure the quick connectors are clasped
firmly.
Align the pull chains from fan with the pull
chain guides on light fixture and then
attach light fixture onto the switch
housing of fan, aligning the holes and
reinstall the set screws.
Remove finial, final cap, hex nut and
rubber washer from light fixture. Keep the
parts.
Install 2 x 9W medium base dimmable
LED bulbs. California Title 24 compliant
bulbs included.
Caution : Approved for use with LED light
bulb only (Part No. 97512S). Do not use
incandescent light bulb .
Caution
: Do not replace bulb until it
cools down.
Blade bracket
Blade
Shipping
stabilizers
Final cap
Finial
Rubber washer
Hex nut
Bulb
Light fixture
Pull chain
guide
This side up