Receiver learning function (DC motor)
After the fan is powered (DC motor), the receiver will start sourcing the frequency in the
first 60 seconds; during the time, any instruction from the transmitter (pressing any but-
ton) will be recognized and memorized as the ID frequency of the using transmitter; fre-
quencies from the other transmitters won’t be identified as the instruction to operate your
fan. When the power is off and on again, if the receiver does not receive the frequency
from the transmitter in 60 seconds, receiver will automatically use last frequency set before
the power off.
Setting up the DIP switch: Follow below steps:
1.Cut off power supply (turn off the power switch) to the fan before setting up and match-
ing between the fan and the transmitter.
2.Then set/change the DIP switch on the transmitter wanted to work with the fan.
3.Then re-connect the power supply (turn on) the fan again.
4.Push any key on transmitter within 60 second, the fan will match and set up with the
transmitter.
5.Repeat the above steps for the other set of fans and transmitters in the house.
Special note:
1.If there is a power failure, and you have more than one fan inside the house, do not
push the transmitter within 60 seconds, otherwise the transmitter signal will be picked up
by all fans and the fans cannot be controlled separately.
2.The fan can remember the running setting before power failure or cut off.
3.If the new fan runs after connected to power, it may be due to the fan remembering the
previous running setting in the factory during the QC process, push “stop” key on trans-
mitter twice to stop.
Operation & Installation:
1. Remove the battery cover and the battery from the transmitter, you will see 4 dipswitch-
es with on/off printing, adjust the dipswitches with your own choice (different combina-
tions).
2. Power your fan, use the transmitter to send the signal to the receiver by pressing any
button on the transmitter, the receiver will memorize the frequency from the transmitter as
the ID signal from now.
Tips for end users:
1. Once the power is off from last using and you want to restart your fan, in case there are
two fans or more in your house with the same transmitter and receiver set, REMEMBER to
wait for 60 seconds before using the transmitter, otherwise it will cause a transmitter to
control both fans in the same time.
2. Receiver has the memory function, fan will automatically return to the previous setting
before power off.
3. If you fan is operated automatically after installation, it is because your fan still memo-
rize the previous setting at factory, just simply press the “stop” button on the transmitter
twice to stop your fan.
