Connect white wire from fan to white
wire from light fixture. Then connect
blue wire from fan to black wire from
light fixture.
Align keyslot holes of the light kit
plate and twist to lock. Install screw
removed in step 23 and tighten
securely.
24
25
Install 3 x 40 watt candelabra base
bulbs, Bulbs included.
warnInG:
Over lamping the fan will result
in the fan lights shutting down
until the proper wattage of
bulbs are installed. reset the
lights by turning off the wall
switch, breaker,or by remote.
replace bulbs with the correct
wattage bulbs, turn the power on.
26
Attach glass to fan by twisting clock-
wise to lock.
27
Lift canopy and install knurled nuts as
shown. Tighten the knurled nuts securely.
The canopy should adjust for any irregu-
larity in the ceiling or Outlet box.
20
Check motor for shipping stabilizers and
remove if present. Insert blades to fan
flywheel and place the reinforce plate
onto the blades as shown.
21
Tighten blade using the screws in hard-
ware pack, repeat this procedure 4 more
times.
22
Loosen 2 screws and remove one screw.
Keep the removed screw for later use.
23
Place face plate over battery compartment and
buttons. Place remote over 2 pins on front
cover. Attach cover of remote by placing over 4
pins and snapping into place.
30
HAND HELD INSTALL
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box. The splices after being
made should be turned upward and pushed carefully
up into the outlet box.
19
The reverse feature of this fan is
controlled by a switch located on top
of the fan body. Turn off the fan and
reverse the fan by slipping the
switch. This will reverse the direction
of the Fan blades.
28
Remove battery cover. Install 12V battery into
wall remote. Duracell MN21 / Eveready A23 / GP
23A all 12V.Attach cover of remote by placing
over buttons and snap the battery cover in
place.
29
