active, processor controlled, stage monitor
M25A
Product Care and Maintenance
To avoid malfunctions and premature degrading of
specifications...
• Never expose the enclosure to heat sources such as radiators
or other products that produce heat.
• Never expose the enclosure to direct sunlight, excessive
vibrations or mechanical shocks.
• Avoid operating and storing the enclosure in dump or dusty
places: this will avoid malfunctions, premature degrading of
specifications.
• Avoid using the enclosure close to strong sources of
electromagnetic interferences (e.g. video monitors, high
power electrical cabling).
This may lead to degradation of audio quality.
• Care should be taken so that objects do not fall and liquid
are not spilled into the enclosure. In public event don't let
people, musicians, technicians or anyone put glasses, cups,
ashtrays or cigarettes on the enclosure.
• Always leave the protective grille mounted on the
enclosure.
• Use a soft brush or a jet of air to clean the enclosure.
Do not use alcohol, solvents or detergents.
• Take care of your connector cables. Make sure that they
are not damaged, knotted or twisted.
• Do not force the connectors and the controls.
• Make sure the mains power switch is off before doing any
connection.
Important !
Power supply connection:
• check that mains voltage corresponds to the voltage
indicated on the panel.
• use the three wire power cord supplied with the enclosure.
• always connect it to a grounded outlet.
Connection to the mixer:
☛
See 'connection example' page
13
If the mixer has XLR balanced outputs:
- use standard balanced XLR connectors (they shall become
automatically unbalanced).
If the mixer has XLR unbalanced outputs:
- in this case, unless you are using a Montarbo mixer, make
sure that the XLR outputs on the mixer are unbalanced to
IEC 268 standard: 1 = GND, 2 = HOT, 3 = GND.
•
Always make sure to use only heavy gauge, high quality
SHIELDED cables
(
signal cables
).
• Always make sure that the mixer, the M25A and
any other powered enclosure are switched
off before
connecting them.
This shall to avoid annoying noises and signal peaks, which
can also be dangerous for the enclosures themselves.
Parallel connection of two or more M25A:
•
Always make sure to use only heavy gauge, high quality
SHIELDED cables
(
signal cables
).
☛
See 'connection example' page
13
9
ENGLISH
Summary of Contents for M25A
Page 1: ...M25A active stage monitor ...
