215 SA
Product Care and Maintenance:
• Never expose the enclosure to heat sources such as radiators
or other products that produce heat.
• Never expose the enclosure to direct sunlight, excessive
vibrations or mechanical shocks.
• Avoid operating and storing the enclosure in dump or dusty
places: this will avoid malfunctions, premature degrading of
specifications.
• Avoid using the enclosure close to strong sources of
electromagnetic interferences (e.g. video monitors, high
power electrical cabling). This may lead to degradation of
audio quality.
• Care should be taken so that objects do not fall and liquid
are not spilled into the enclosure. In public event don't let
people, musicians, technicians or anyone put glasses, cups,
ashtrays or cigarettes on the enclosure.
• As satellite supporting pole we recommend the Montarbo
SM4
.
• Always leave the protective grille mounted on the
enclosure.
• Use a soft brush or a jet of air to clean the enclosure.
Do not use alcohol, solvents or detergents.
• Take care of your connector cables. Make sure that they
are not damaged, knotted or twisted.
• Do not force the connectors and the controls.
Important !
Power supply connection:
• make sure the mains power switch is off ('0') before
starting any connection.
• check that mains voltage corresponds to the voltage
indicated on the panel.
• always connect the power cord to a grounded outlet.
Connection to the mixer:
If the mixer has XLR balanced outputs:
- use standard balanced XLR connectors.
If the mixer has XLR unbalanced outputs:
- in this case, unless you are using a Montarbo mixer, make
sure that the XLR outputs on the mixer are unbalanced to
IEC 268 standard: 1 = GND, 2 = HOT, 3 = GND.
If the mixer has JACK unbalanced outputs:
- use suitable Jack-XLR male adapters unbalanced according
to IEC 268: tip = pin 2, ground = pin 1, + = pin 3.
☛
See 'connectors' at page
17
.
• Always use only heavy gauge, high quality
SHIELDED
cables
(signal cables).
• Always make sure that the mixer, the 215SA and
any other powered enclosure are switched
off
before
connecting them.
This shall to avoid annoying noises and signal peaks, which
can also be dangerous for the enclosures themselves.
13
ENGLISH
Summary of Contents for 215 SA
Page 1: ...215SA active subwoofer...
